Vir2 Instruments Studio Kit Builder - Manual (Page 20)

STUDIO KIT BUILDER
15
STUDIO KIT BUILDER FX
Each effect has an On/Off button. By default, all effects are off unless the
current kit preset utilizes any of the effects. To exit the FX window, simply
click the “Close FX” button.
You may have noticed that there are lines with arrows that connect each of
the effects, running from the upper left hand side of the FX window down to
the bottom right. These lines diagram the audio path. Audio will on be
processed by an effect when it is ON, otherwise the audio will pass through
unchanged.
If you are unfamiliar with any of the available effects, below is a brief
description to help acquaint you each of them:
Sends – Each knob sets the amount of signal that is sent to these effects.
The controls for these effects are available in the Send FX window. The Send
FX window can be accessed by clicking the SEND button below the
MASTER OUT buss on either mixer view.
More detailed information on the “Sends” can be found on page 19 & 20.