3 pipework – Watson-Marlow Bredel 265 User Manual

Page 25

Advertising
background image

INSTALLATION

25

5.3.3

Pipework

When determining and connecting suction and
discharge lines consider the following points:

•

The bore size of the suction and discharge lines
must be larger than the bore size of the pump
hose. For more information consult your Bredel
representative.

•

Limit the presence of sharp bends in the
discharge line. Make sure that the radius of the
bent discharge line is as large as possible
(preferably R=4d to 5d). It is recommended to
use Y-connections instead of T-connections.

•

Keep the piping at a minimum equal to or
greater than the bore size of the pump. Increase
the bore size of the pipe work when the duty
fluid has a high velocity or inertia. This will help
keep friction and impulse losses to a minimum.
Where critical velocities are a concerned,
consult your Bredel representative.

•

For the flexible hoses select compatible
materials and ensure the installation is suited
for the design pressure of the system.

•

Keep the delivery and suction lines as short and
direct as possible.

•

Prevent any possibilities of exceeding the
maximum working pressure of the hose pump.
See §

11.1.1

. If necessary fit a pressure relief

valve or shutdown switch. Consult your Bredel
representative for detailed information.

•

Consult your Bredel representative for
recommendations on mounting pulsation
dampening devices. A pulsation dampener and/

CAUTION
Consider the maximum permissible work-
ing pressure on the discharge side.
Exceeding the maximum working pressure
may lead to serious damage to the pump.

Advertising
This manual is related to the following products: