Watson-Marlow Bredel 265 - Manual (Page 44)

MAINTENANCE
44
2. The pump housing can be filled with lubricant
via the breather/vent (A) on the rear of the
pump housing. For this purpose remove the
breather cap (B) and position a funnel (C) in the
breather. In order to facilitate the filling with
lubricant the plug (D) on the front of the pump
housing can be removed. Pour the lubricant in
the pump housing via the funnel. Continue until
the lubricant level has reached above the
minimum level line.
8.5 Changing oil in gearbox
1. Isolate the pump from the electrical supply.
2. Position a tray under the gearbox.
3. See the gearbox manual for procedure on oil
change.
4. Switch on the electrical supply to the pump.
8.6 Replacing pump hose
8.6.1 Removing pump hose
1. Isolate the pump from the electrical supply.
2. Close any shut-off valves in both the suction
and discharge line to minimize product loss.
D B
C
A
For the required quantity of lubricant, see
§
11.1.4 .
See the gearbox manual for service inter-
vals and advised lubricants.