Watson-Marlow Bredel 265 - Manual (Page 50)

MAINTENANCE
50
8. Turn the rotor in such a way that the hose (A) is
pressed firmly against the flange surface (B).
9. Now fully tighten the retaining bolts (A) of the
flange bracket (B). Make sure the bolts are
tightened with the correct torque. See §
11.1.6 .
10. Position hose clamp (A) against O-ring chamber
of the flange bracket (B) and fasten the
retaining bolt. Make sure the bolts are tightened
with the correct torque. See §
11.1.6 .
11. Now fit the other port. For this port proceed in
the same way as described above for the inlet
port.
12. Fill the pump housing with Bredel Genuine
Hose Lubricant. See §
8.4 .
13. Fit the suction and discharge lines (B) and the
retaining bolts (A). Tighten the retaining bolts
with the correct torque. See §
11.1.6 .
A
B B
A
A
B
A
B
A
B