Westermo TD-32 - Manual (Page 32)

32 6178-2203
&Wn – Save Current Configuration
Saves the current (active) configuration, including S-registers, in one of the user profiles in NVRAM.
The current configuration is replaced with the one stored in one of the user profiles when the modem
is re-started or when the Zn command is sent to the modem.
&W0 Store the current configuration in profile 0.
&W1 Store the current configuration in profile 1.
Please also refer to AT&Y
Xn – Extended Result Codes
This command selects which type of messages will be sent to the terminal to report the result of
dialling attempts.
X0 Disables monitoring of busy tones.
The messages that will be sent are: OK, CONNECT, RING, NO CARRIER, ERROR
and NO ANSWER.
For instance: when no dialling tone is detected NO CARRIER is sent to the terminal.
X1 Disables monitoring of busy tones.
The messages that will be sent are: OK, CONNECT, RING, NO CARRIER, ERROR,
NO ANSWER and CONNECT xxxxx (x= rate)
X2 Disables monitoring of busy tones.
The messages that will be sent are: OK, CONNECT, RING, NO CARRIER, ERROR,
NO DIALTONE, NO ANSWER and CONNECT xxxxx (x= rate)
X3 Enables monitoring of busy tones.
The messages that will be sent are: OK, CONNECT, RING, NO CARRIER, ERROR,
NO ANSWER, and CONNECT xxxxx (x= rate)
X4 Enables monitoring of busy tones.
All messages will be sent to the terminal. (Default)
Please also refer to ATD, ATQn, ATVn and ATWn