Westermo TD-32 - Manual (Page 7)

25-pos. Screw Direction Name Description
D-sub Terminal DCE-DTE
1 - - - PE Protective earth
2 8 TXD Transmit data
3 7 RXD Receive data
4 6 RTS Request to send
5 5 CTS Clear to send
6 2 DSR Modem ready
7 1 - - - SG Signal ground
8 4 DCD Data carrier detect
9 Continuous high
10 Continuous low
12 DRS Speed indication (1200/2400)
15 TXC Synchronous TXD clock from modem
17 RXC Synchronous RXD clock from modem
20 3 DTR Data terminal ready
21 RDL Request of remote digital loop back
22 9 RI Ring indicator
23 DRS Data speed select (1200/2400)
24 EXC External synchronous clock
25 TI Test indication signal
7 6178-2203
RS-232/V.24 Connections
Pin outs for the 25-pole D-sub and 9-pole screw terminal:
The other pins in the 25-pole D-sub should be left unconnected.
←
←
←
←
←
←
←
←
←
←
←
←
←
←
←
←
←
Line connection
The telephone line is connected to the 6-pole RJ-12
connector or to the 4-pole screw block in the bottom
left side.
When using the screw-block a strap plug supplied must
be placed in the RJ-12 connector.
If this is not done the outgoing signal will not be
connected to the screw-block. 1
:
6
1 2 3 4
2-wire lines are connected to the two middle pins (3 & 4)
in the RJ-12 plug or the TX screws (1 & 2).
In the UK modems the 2-wire line is connected to pin 2 & 5
in the RJ-12 connector.
4-wire lines are connected to the screw terminal, transmitter
to TX (1 & 2) and receiver to RX (3 & 4).
12345678