Westermo TD-32 - Manual (Page 42)

42 6178-2203
S31 – Bit Mapped Option Status (Read only)
Bit Interval Default Description
0 – – Reserved
1 0..1 1 Automatic line setting:
0-ATN0
1-ATN1
2..3 0..2 1 Error correction messages:
0-Reports only speed on serial port
(ATW0)
1-Reports line speed and speed on
serial port (AT&W1)
2-Reports only line speed (ATW2)
4..7 – 0 Reserved
S32 – XON Character (Not stored with &W)
The register is used for setting the character that will be recognised as XON flow control character.
Default 17 {0..255} (ASCII decimal).
S33 – XOFF character (Not saved with &W)
The register is used for setting the character that will be recognised as XOFF flow control character.
Default 19 {0..255} (ASCII decimal).
S36 – LAP-M Failure Control
The register indicates what should happen upon V.42 LAPM connect failure.
0-The modem disconnects (AT\N4)
1-The modem stays on-line and a direct mode connection is established (AT\N1)
2-Reserved
3-The modem stays on-line and a normal mode connection is established (AT\N0)
4-An MNP-connection is attempted and if it fails, the modem disconnects (AT\N5)
5-An MNP-connection is attempted and if it fails, a direct mode connection is established.
6-Reserved
7- An MNP-connection is attempted and if it fails, a normal mode connection is established.
(AT\N3)
Default 7 {0..7}
Please also refer to S48, \N
S37 – Bit mapped register
Bit Interval Default Description
0..7 0..7 0 Selection of line modulation:
0-Selects automatic line
modulation (ATF0)
1..3-V.21 or Bell 103 mod (ATF1)
5-V.22 or Bell 212A mod (ATF4)
6-V.22bis mod (ATF5)
8-V.32bis/V.32 4 800 bit/s (ATF6)
9-V.32bis/V.32 9 600 bit/s (ATF8)
10-V.32bis 12 000 bit/s (ATF9).
11-V.32bis 14 400 bit/s (ATF10).
12-V.32bis 7 200 bit/s (ATF7).