ARM Electronics DVRHD OSD - Manual (Page 21)

OSD Setup Manual
20
- PPPoE Password
The item allows users to setup the PPPoE password. Follow these steps
to setup the login password.
x Select <PPPoE Password> from LAN Setup menu and press ENTER.
A virtual keyboard displays.
x Use Direction keys to select from characters.
x Press ENTER to add the selected character to the entry field.
x When it’s done, move the cursor to <OK> and press ENTER to save
the setting and exit.
- PPPoE Max Idle
The item indicates the duration that the modem connection remains
active if there is no acknowledgement from the remote PC. Users can
select the idle time from 0 to 600 minutes.
- Connect At Booting
The DVR is allowed to automatically connect to the internet when booting
up. Select <Yes> to connect at booting, otherwise select <No>.
- Network Restart
Network restart is required after network settings are changed. Select
<Yes> to restart the network connection.
„ Trigger Port
To avoid the default service port (port 80) being jammed, this item enables users to
change port 80 to another port.
To change the trigger port, move the cursor over <Trigger Port> and press ENTER,
then adjust the setting by UP / DOWN keys.
„ Email Address
This item is used to edit the e-mail address where alarm event information will be
sent. Follow these steps to setup the e-mail address.
x Select <Email Address> from Network Setup menu and press ENTER. A
virtual keyboard displays.
x Use Direction keys to move the cursor for selecting from characters.
x Press ENTER to add the selected character to the entry field.
x When it’s done, move the cursor to <OK> and press ENTER to save the
settings and exit.