ARM Electronics DVRHD OSD - Manual (Page 43)

OSD Setup Manual
42
Sequence Setup ʳ ʳ ʳ ʳ
The Sequence Setup menu allows users to set the camera sequence schedule and dwell
time for main and call monitor. Select <Sequence Setup> in main menu and press ENTER.
The menu displays as follows.
Sequence Setup
Main Monitor Dwell
Main Monitor Schedule
Call Monitor Dwell
Call Monitor Schedule 5 Sec
5 Sec
Items in the <Sequence Setup> menu are described in the following subsections.
< Main / Call Monitor Dwell >
The main/ call monitor can be set to display full screen video of all installed cameras in
sequence. This item is used to set the Main/ Call Monitor dwell time, which is the duration of
time elapsed before switching to the next channel. The dwell time is in the range of 1 to 120
seconds.
< Main / Call Monitor Schedule >
This item is used to set displaying sequence of connected cameras to be displayed on the
main/ call monitor in full-screen format
. Move the cursor to <Main Monitor Schedule> and
press ENTER. The menu is displayed as follows.
Main Monitor Schedule
_Ź_Ź_Ź_Ź_Ź_Ź_Ź_Ź
_Ź_Ź_Ź_Ź_Ź_Ź_Ź_
Press Channel Keys To Select Channel
Press Ż Key To Delete
Follow these steps to set a sequence:
x
Press LEFT direction key to delete the original setting.
x
Press the desired Channel keys to assign the camera to the position where
the cursor stops.
x
Continue the steps until the sequence is completed.
The maximum number of entries in a sequence equals to the number of channels. Users
can select fewer than the maximum entries for camera sequence and leave the remaining
entries blank. The sequence can include a specific camera or cameras multiple times.