H3C Technologies H3C S7500E Series Switches - Manual (Page 105)

10-4
Dynamic Domain Name Resolution Configuration Example
Network requirements
As shown in Figure 10-2 , the IPv6 address of the DNS server is 2::2/64 and the name suffix is com.
The mapping between domain name host and IPv6 address 1::1/64 is stored in the com domain.
Dynamic domain name resolution and the domain name suffix are configured on the Switch that
serves as a DNS client, and thus the Switch can use domain name host to access the host with the
domain name host.com and the IPv6 address 1::1/64.
Figure 10-2 Network diagram of dynamic domain name resolution
Configuration procedure
z Before performing the following configuration, make sure that the Switch and the host are
accessible to each another via available routes, and the IPv6 addresses of the interfaces are
configured as shown Figure 10-2 .
z This configuration may vary with different DNS servers. The following configuration is performed
on a PC running Windows server 2003. Make sure that the DNS server supports the IPv6 DNS
function so that the server can process IPv6 DNS packets, and the interfaces of the DNS server
can forward IPv6 packets.
1) Configure the DNS server
# Enter the DNS server configuration page.
Select Start > Programs > Administrative Tools > DNS.
# Create zone com.