H3C Technologies H3C S7500E Series Switches - Manual (Page 184)

15-27
# Configure a static route from Switch B through the interface tunnel 2 to Group 1.
[SwitchB] ip route-static 10.1.1.0 255.255.255.0 tunnel 2
Configuration verification
After the above configuration, display the status of the tunnel interfaces on Switch A and Switch B:
<SwitchA> display interface tunnel 1
Tunnel1 current state: UP
Line protocol current state: UP
Description: Tunnel1 Interface
The Maximum Transmit Unit is 1480
Internet Address is 10.1.2.1/24 Primary
Encapsulation is TUNNEL, service-loopback-group ID is 1.
Tunnel source 2.1.1.1, destination 3.1.1.1
Tunnel protocol/transport IP/IP
Last clearing of counters: Never
Last 300 seconds input: 0 bytes/sec, 0 packets/sec
Last 300 seconds output: 2 bytes/sec, 0 packets/sec
4 packets input, 256 bytes
0 input error
12 packets output, 768 bytes
0 output error
<SwitchB> display interface tunnel 2
Tunnel2 current state: UP
Line protocol current state: UP
Description: Tunnel2 Interface
The Maximum Transmit Unit is 1480
Internet Address is 10.1.2.2/24 Primary
Encapsulation is TUNNEL, service-loopback-group ID is 1.
Tunnel source 3.1.1.1, destination 2.1.1.1
Tunnel protocol/transport IP/IP
Last clearing of counters: Never
Last 300 seconds input: 0 bytes/sec, 0 packets/sec
Last 300 seconds output: 0 bytes/sec, 0 packets/sec
5 packets input, 320 bytes
0 input error
9 packets output, 576 bytes
0 output error
# Ping the IPv4 address of the peer interface VLAN-interface 100 from Switch A.
[SwitchA] ping 10.1.3.1
PING 10.1.3.1: 56 data bytes, press CTRL_C to break
Reply from 10.1.3.1: bytes=56 Sequence=1 ttl=255 time=15 ms
Reply from 10.1.3.1: bytes=56 Sequence=2 ttl=255 time=15 ms
Reply from 10.1.3.1: bytes=56 Sequence=3 ttl=255 time=16 ms
Reply from 10.1.3.1: bytes=56 Sequence=4 ttl=255 time=16 ms
Reply from 10.1.3.1: bytes=56 Sequence=5 ttl=255 time=15 ms
--- 10.1.3.1 ping statistics ---
5 packet(s) transmitted
5 packet(s) received
0.00% packet loss