H3C Technologies H3C S7500E Series Switches - Manual (Page 192)

15-35
Make sure that Switch A and Switch B have the corresponding VLAN interfaces created and are
reachable to each other.
z Configuration on Switch A
# Enable IPv6.
<SwitchA> system-view
[SwitchA] ipv6
# Configure an IPv6 address for VLAN-interface 100.
[SwitchA] interface vlan-interface 100
[SwitchA-Vlan-interface100] ipv6 address 2002:1::1 64
[SwitchA-Vlan-interface100] quit
# Configure an IPv6 address for VLAN-interface 101.
[SwitchA] interface vlan-interface 101
[SwitchA-Vlan-interface101] ipv6 address 2002::11:1 64
[SwitchA-Vlan-interface101] quit
# Create the interface tunnel 1.
[SwitchA] interface tunnel 1
# Configure an IPv6 address for the interface tunnel 1.
[SwitchA-Tunnel1] ipv6 address 3001::1:1 64
# Configure the tunnel encapsulation mode.
[SwitchA-Tunnel1] tunnel-protocol ipv6-ipv6
# Configure the source address for the interface tunnel 1 (IP address of VLAN-interface 101).
[SwitchA-Tunnel1] source 2002:11::1
# Configure the destination address for the interface tunnel 1 (IP address of VLAN-interface 101 of
Switch B).
[SwitchA-Tunnel1] destination 2002::22:1
[SwitchA-Tunnel1] quit
# Create service loopback group 1 to support the tunnel service.
[SwitchA] service-loopback group 1 type tunnel
# Add GigabitEthernet 2/0/3 to service loopback group 1.
[SwitchA] interface GigabitEthernet 2/0/3
[SwitchA-GigabitEthernet2/0/3] undo stp enable
[SwitchA-GigabitEthernet2/0/3] port service-loopback group 1
[SwitchA-GigabitEthernet2/0/3] quit
# Reference service loopback group 1 on the tunnel.
[SwitchA] interface tunnel 1
[SwitchA-Tunnel1] service-loopback-group 1
[SwitchA-Tunnel1] quit
# Configure a static route from Switch A through the interface tunnel 1 to Group 2.
[SwitchA] ipv6 route-static 2002:3:: 64 tunnel 1
z Configuration on Switch B
# Enable IPv6.