H3C Technologies H3C S3100 Series Switches - Manual (Page 128)

1-11
Displaying and Maintaining Voice VLAN
To do… Use the command… Remarks
Display information about the ports on which voice VLAN
configuration fails
display voice vlan error-info
Display the voice VLAN configuration status display voice vlan status
Display the OUI list display voice vlan oui
Display the ports operating in the voice VLAN display vlan vlan-id
In any view
Voice VLAN Configuration Example
Voice VLAN Configuration Example (Automatic Voice VLAN Assignment Mode)
Network requirements
Create a voice VLAN and configure it to operate in automatic voice VLAN assignment mode to enable
the port to which an IP phone is connected to join or exit the voice VLAN automatically and voice traffic
to be transmitted within the voice VLAN.
z Create VLAN 2 and configure it as the voice VLAN, with the aging timer being 100 minutes.
z The IP phone sends tagged packets. It is connected to Ethernet 1/0/1, a hybrid port, with VLAN 6
being its default VLAN. Set this port to operate in automatic voice VLAN assignment mode.
z You need to add a user-defined OUI address 0011-2200-000, with the mask being ffff-ff00-0000
and the description string being “test”.
Network diagram
Figure 1-2 Network diagram for voice VLAN configuration (automatic voice VLAN assignment mode)
Internet
Device A
Eth1/0/1
VLAN2
VLAN2
010-1001
OUI:0011-2200-0000
Mask:ffff-ff00-0000
Device B
Configuration procedure
# Create VLAN 2 and VLAN 6.
<DeviceA> system-view
[DeviceA] vlan 2
[DeviceA-vlan2] quit
[DeviceA] vlan 6
[DeviceA-vlan6] quit