H3C Technologies H3C S3100 Series Switches - Manual (Page 799)

1-13
Setting to Output System Information to the SNMP NMS
Table 1-15 Set to output system information to the SNMP NMS
Operation Command Description
Enter system view system-view —
Enable the information center info-center enable
Optional
Enabled by default.
Enable information output to the
SNMP NMS info-center snmp channel
{ channel-number | channel-name }
Optional
By default, the switch outputs trap
information to SNMP through
channel 5.
Configure the output rules of
system information
info-center source { modu-name |
default } channel
{ channel-number | channel-name }
[ { log | trap | debug } { level
severity | state state } ]*
Optional
Refer to Table 1-8 for the default
output rules of system information.
Set the format of time stamp in the
output information
info-center timestamp { log | trap
| debugging } { boot | date |
none }
Optional
By default, the time stamp format
of the information output to the
SNMP NMS is date.
To send information to a remote SNMP NMS properly, related configurations are required on both the
switch and the SNMP NMS.
Displaying and Maintaining Information Center
After the above configurations, you can execute the display commands in any view to display the
running status of the information center, and thus validate your configurations. You can also execute the
reset commands in user view to clear the information in the log buffer and trap buffer.
Table 1-16 Display and maintain information center
Operation Command Description
Display information on an
information channel display channel [ channel-number |
channel-name ]
Display the operation status of
information center, the
configuration of information
channels, the format of time stamp
display info-center [ unit unit-id ]
Display the status of log buffer and
the information recorded in the log
buffer display logbuffer [ unit unit-id ] [ level severity
| size buffersize ]* [ | { begin | exclude |
include } regular-expression ]
Display the summary information
recorded in the log buffer
display logbuffer summary [ level severity ]
Available in any view