H3C Technologies H3C S3100 Series Switches - Manual (Page 99)

2-8
Configuring a MAC-Based VLAN
Configuration prerequisites
Create a VLAN before configuring the VLAN as a protocol-based VLAN.
Configuration procedure
Follow these steps to configure a MAC-based VLAN:
To do... Use the command... Remarks
Enter system view system-view —
Associate MAC addresses
with a VLAN
mac-vlan mac-address
mac-address vlan vlan-id [ priority
priority ]
Required
Enter Ethernet interface view
interface interface-type
interface-number
Required.
In Ethernet interface view, the
subsequent configurations apply only
to the current port.
Configure the link type of the
port(s) as hybrid
port link-type hybrid Required
Configure the current hybrid
port(s) to permit packets of
specific MAC-based VLANs to
pass through
port hybrid vlan vlan-id-list
{ tagged | untagged }
Required
By default, a hybrid port only permits
the packets of VLAN 1 to pass
through.
Enable MAC-based VLAN mac-vlan enable
Required
Disabled by default
Displaying MAC-Based VLAN Configuration
To do... Use the command…
Display MAC address-to-VLAN
entries
display mac-vlan { all | dynamic | static | vlan vlan-id }
Display all interfaces with
MAC-based VLAN enabled
display mac-vlan interface
Configuring a Protocol-Based VLAN
The contents of this section are only applicable to the S3100-EI series among S3100 series switches.