H3C Technologies H3C S3100 Series Switches - Manual (Page 958)

2-4
Operation Command Remarks
Monitor Link
group view port interface-type
interface-number uplink
quit
interface interface-type
interface-number
Configure
the specified
Ethernet port
as the uplink
port of the
Monitor Link
group
Ethernet
port view
port monitor-link group
group-id uplink
Configuring a Downlink Port
Table 2-4 Configure a downlink port
Operation Command Remarks
Enter system view system-view —
Enter the specified Monitor Link group view monitor-link group group-id Required
Configure the specified link
aggregation group as a
downlink port of the Monitor
Link group
link-aggregation group
group-id downlink
Monitor Link
group view port interface-type
interface-number downlink
quit
interface interface-type
interface-number
Configure a
downlink
port for the
Monitor Link
group
Configure
the specified
Ethernet port
as a
downlink
port of the
Monitor Link
group
Ethernet port
view
port monitor-link group
group-id downlink
Required
Use either
approach
z A Smart Link/Monitor Link group with members cannot be deleted. A Smart Link group as a Monitor
Link group member cannot be deleted.
z The Smart Link/Monitor Link function and the remote port mirroring function are incompatible with
each other.
z If a single port is specified as a Smart Link/Monitor Link group member, do not use the lacp enable
command on the port or add the port to another dynamic link aggregation group because doing so
will cause the port to become an aggregation group member.
z Using the copy command on a port does not copy the Smart Link/Monitor Link group member
information configured on the port to any other port.
Displaying Monitor Link Configuration
After the above-mentioned configuration, you can use the display command in any view to display the
information about Monitor Link, so as to verify configuration result.