Installing an sfe-x1 switching fabric module – H3C Technologies H3C SR6600-X User Manual
Page 25
15
Figure 12 Installing an MPU
Installing an SFE-X1 switching fabric module
Only the Slot 6 of the SR6616-X supports the SFE-X1 switching fabric module.
Before the installation, make sure the ejector levers of the SFE-X1 are outwards.
To install an SFE-X1:
1.
Face the front of the router and locate the slot.
2.
Loosen the captive screws with a Phillips screwdriver to remove the filler panel from the slot.
Keep the removed filler panel for future use.
3.
Insert the SFE-X1 slowly along the slide rails until positioning pins on the backplane are seated in
the positioning holes, and then push the ejector levers inward to lock the SFE-X1 in position.
4.
Use a Phillips screwdriver to fasten the captive screws on the two sides of the SFE-X1.
For the SFE-X1 LED description, see "