H3C Technologies H3C SR6600-X - Manual (Page 63)

53
Figure 65 Pulling the RSE-X2 MPU out of the slot
4. Install a new MPU. For the installation procedure, see " Installing an RSE-X2 MPU ."
If you do not install a new MPU in the slot, install a filler panel.
Replacing an SFE-X1
1. Face the front of the router and locate the SFE-X1 to be removed.
2. Use a Phillips screwdriver to completely loosen the captive screws on the SFE-X1.
3. Holding the ejector levers of the SFE-X1 with both hands, pull the ejector levers outward, and
gently pull the SFE-X1 out of the slot along the slide rails.