H3C Technologies H3C MSR 50 - Manual (Page 80)

72
Step2 Align the edges of the MSCA with the guides in the MSCA slot and push the card into the router. Push
the ejector levers at both side of the MSCA inward until they form the smallest degree with the MPUF
panel.
Step3 Fix the MSCA on the router with captive screws.
NOTE:
The installation and removal procedures of an MSCB are the same as that of an MSCA.
Installing/Removing CF Card
CF Card Structure
Figure 54 Front of CF card
Installing CF Card
Figure 55 Press the CF card into the slot
Install the CF card following these steps:
Step1 Push the spring button into the slot completely, and make sure it only springs out with outside force.
Step2 Press the CF card into the slot in correct orientation, and make sure it only springs out with outside force.
NOTE:
Make sure the CF card with correct application program is properly installed in the slot; or, the system
cannot boot.
Removing CF Card
Remove the CF card following these steps:
Step1 Check the CF card LED to make sure it is not blinking, and then proceed.
Step2 Press the spring button to release the internal spring clip, making the card out of the slot a little.