H3C Technologies H3C MSR 30 - Manual (Page 45)

37
Installing a DSIC/DMIM Interface Card
Follow these steps to install a DSIC/DMIM interface card:
Step1 Remove the blank panel covering the slot and keep it for future use.
Step2 Determine the interface card type.
Step3 Loosen the captive screws with a Philips screwdriver and remove the slide rails for future use. Slide rails
at both the right and left sides need to be removed in case a DMIM interface card is to be installed.
Step4 Insert the interface card in the slot and fasten the screws with a screwdriver.
Figure 38 Remove the slide rail
Figure 39 Draw the left MIM slide rail out of the slot
Figure 40 Draw the right MIM slide rail out of the slot