H3C Technologies H3C MSR 30 - Manual (Page 88)

80
Structure
Figure 77 Front view of CF card
Installing CF Card
Install the CF card following these steps:
Step1 Push the ejector button into the slot completely, and make sure it only springs out with outside force.
Step2 Press the CF card into the slot in correct orientation, and make sure it only pops up with outside force.
Figure 78 Press the CF card into the slot
NOTE:
Make sure the CF card with correct application program is properly installed in the slot; or, the system
cannot boot.
Removing CF Card
Remove the CF card following these steps:
Step1 Check the CF card LED to make sure it is not blinking, and then proceed.
Step2 Press the spring button to release the internal spring clip, making the card out of the slot a little.
Step3 Push the spring button hard in the orientation shown in the figure below, and the CF card on the right
pops up a little. Take it out.