Configuring portal server on imc plat 5.0, Figure 94 – H3C Technologies H3C WX3000E Series Wireless Switches User Manual
Page 208
Advertising
194
Figure 94 Adding a port group
5.
Select Service Parameters > Validate System Configuration from the navigation tree to validate the
configurations.
Configuring portal server on IMC PLAT 5.0
NOTE:
This example assumes that the portal server runs on IMC PLAT 5.0(E0101) and IMC UAM 5.0(E0101).
1.
Configure the portal server:
a.
Log in to IMC and click the Service tab.
b.
Select User Access Manager > Portal Service Management > Server from the navigation tree to
enter the portal server configuration page, as shown in
c.
Configure the portal server parameters as needed. This example uses the default settings.
d.
Click OK.
Advertising
This manual is related to the following products: