H3C Technologies H3C WX3000E Series Wireless Switches User Manual
Page 84
70
Select the User tab, and select Access User View > All Access Users from the navigation tree to enter the
All Access Users page. Then, click Add to enter the Add Access User page and perform the following
configurations as shown in
•
Select the user or add a user named hello
•
Specify the account name as portal and configure the password
•
Select the access service Portal-auth/acct
•
Configure other parameters accordingly and click OK to finish the operation
Figure 22 Adding an access user account
2.
Configure the RADIUS server (when the server runs on IMC PLAT 5.0)
NOTE:
This section assumes that the RADIUS server runs on IMC PLAT 5.0 (E0101H03) and IMC UAM 5.0 SP1
(E0101P03).
# Add an access device.
Log in to IMC, click the Service tab, and select User Access Manager > Access Device Management >
Access Device from the navigation tree. Then, click Add to configure an access device as follows:
•
Set the shared key for authentication and accounting to expert
•
Set the ports for authentication and accounting to 1812 and 1813 respectively
•
Select LAN Access Service as the service type
•
Select H3C(General) as the access device type
•
Select the access device from the device list or manually add the device with the IP address 10.1.1.2
•
Leave the default settings for other parameters and click OK to finish the configuration.