H3C Technologies H3C WX3000E Series Wireless Switches - Manual (Page 266)

252
• For super passwords, the settings configured specifically for super passwords, if any, override those
configured in system view.
To configure password control:
Task Remarks
Enabling password control Required.
Setting global password control parameters Optional.
Setting user group password control parameters Optional.
Setting local user password control parameters Optional.
Setting super password control parameters Optional.
Setting a local user password in interactive mode Optional.
Configuring password control
Enabling password control
To enable password control functions:
1. Enable the global password control feature in system view.
Only after the password control feature is enabled globally, can password control configurations
take effect.
2. Enable password control functions individually.
The following password control functions need to be enabled individually after the password
control feature is enabled globally:
{
Password aging
{
Minimum password length
{
Password history
{
Password composition checking
You must enable a function for its relevant configurations to take effect.
To enable password control:
Step Command Remarks
1. Enter system view. system-view N/A
2. Enable the global password
control feature.
password-control enable
By default, the global password
control feature is disabled.
3. Enable a password control
function individually.
password-control { aging |
composition | history | length }
enable
Optional.
By default, all of the four password
control functions are enabled.
NOTE:
After global password control is enabled, local user passwords configured on the device are not displayed
when you use the corresponding display command.