Grass Valley NewsroomSuite v.5.5 - Manual (Page 42)

Chapter 3 Installing the NewsEdit SC Video Board and Breakout Box (Optional)
38 Digital News Production
Installing the XenaSD Board and Breakout Box
The XenaSD board installs in the NewsEdit SC computer and connects to the
Breakout Box.
To install the XenaSD board:
1. Remove the cover from the NewsEdit SC computer.
2. Insert the XenaSD board into an available slot.
3. Replace the cover on the NewsEdit SC computer.
4. Connect the cables as follows:
a. Using the cable provided with the KL Breakout Box, connect the 60-pin
connector and the three BNC connectors (labeled SDI IN, SDI OUT 1,
and SDI OUT 2) to the back of the Breakout Box.
b. Connect the other end of the cable to the XenaSD board in the NewsEdit
SC computer.
NOTE: If you aren’t using the Breakout Box, use the octopus cable
provided with the XenaSD board to connect the board directly to your
components.
5. Connect video and audio cables to the Breakout Box as needed for your
newsroom setup.
Balanced Audio IN
Channels 1 & 2
Balanced Audio OUT
Channels 1 & 2
AES/EBU Audio
IN & OUT
Serial
Digital
IN
Serial
Digital
OUT
External
Reference
(loop)
Composite/
Component
Video IN
Composite/
Component
Video OUT
RS-422
Machine
Control
Analog Audio
Output
Ch. 1 In Ch. 1 Out Ch. 2 In Ch. 2 Out Ch. 1/2 In Ch. 1/2 Out
BALANCED AUDIO
Ch. 1/2
AES/EBU
Audio
In
Out
In
Out
In
Out
In
Out
1 2
SDI Ref Loop Y/CVBS Pb/Y Pr/C Ch.1(L) Ch.2(R)
RS-422