Grass Valley PDX 218 - Manual (Page 48)

Chapter 3 Service
3-14 PDX 218 Instruction Manual
Removing the Disk Tray Cover
Figure 3-9 shows removal of the disk tray cover, which must be removed to gain
access for removal of other parts.
To remove the disk tray cover:
1. Remove the PDX 218 from the equipment rack.
2. Remove the top cover (Figure 3-8).
3. Unsnap the front panel bezel (Figure 3-1).
4. Remove the front panel retaining screws and lower the front panel (Figure 3-4).
5. Remove all disk drive caddies (Figure 3-5).
6. Remove the screws and L-brackets, one on each side (Figure 3-9).
7. Remove the Disk Tray cover mounting screws.
8. Slide the Disk Tray cover out through the front of the chassis.
To install the disk tray cover:
1. Slide the Disk Tray cover in through the front of the chassis and secure with the
screws previously removed (Figure 3-9).
2. Install the L-brackets with the screws previously removed.
3. Install all disk drive caddies (Figure 3-5) previously removed.
4. Raise the front panel and secure with the screws previously removed (Figure 3-4).
5. Position the front panel bezel mounting posts over the holes in the front panel and
press firmly until the bezel snaps back in place (Figure 3-1).
6. Replace the top cover (Figure 3-8).
7. Reinstall the PDX 218 into the equipment rack.