Grass Valley PDX 218 - Manual (Page 51)

Removing and Replacing a SCSI Cable
PDX 218 Instruction Manual 3-17
To remove an internal SCSI cable:
1. Remove the PDX 218 from the equipment rack.
2. Remove the top cover (Figure 3-8).
3. Remove the Disk Tray cover (Figure 3-9).
4. If necessary, remove disk caddie(s).
5. Disconnect the bad SCSI cable connector from the SCSI Distribution board (Figure
3-10).
6. Disconnect the connector at the other end of the bad SCSI cable from the rear
panel.
To install a SCSI cable:
1. Connect the SCSI cable from the appropriate rear panel connector to the
appropriate SCSI connector on the SCSI Distribution board (Figure 3-10).
2. Install any disk caddies previously removed.
3. Install the Disk Tray cover (Figure 3-9).
4. Replace the top cover (Figure 3-8).
5. Reinstall the PDX 218 into the equipment rack.