Grass Valley PDX 218 User Manual
Page 53
Removing and Replacing the SCSI Distribution
PDX 218 Instruction Manual
3-19
To remove the SCSI Distribution board power cable:
1. Remove the PDX 218 from the equipment rack.
2. Remove the top cover (Figure 3-8).
3. Remove the Disk Tray cover (Figure 3-9).
4. Remove as many caddies as necessary to access the Power Supply connector on the
left side of the SCSI Distribution board (Figure 3-5).
5. Disconnect the Power Supply connector from the SCSI Distribution board (Figure
3-11).
6. Remove the air baffle.
7. Disconnect the SCSI Distribution board power cable wires from the Power Supply.
To install the SCSI Distribution board power cable:
1. Connect the cable wires to the left side (as facing the chassis) of the Power Supply
(see the insert in Figure 3-11).
2. Connect the Power Supply cable connector to the SCSI Distribution board.
3. Reinstall the air baffle.
4. Install the Disk Tray cover (Figure 3-9).
5. Replace the top cover (Figure 3-8).
6. Reinstall the PDX 218 into the equipment rack.