Polaris 2013 BRUTUS Owner's Manual - Manual (Page 117)

116
MAINTENANCE
Battery
Improperly connecting or disconnecting battery cables can result in
an explosion and cause serious injury or death. When removing the
battery, always disconnect the negative (black) cable first. When
reinstalling the battery, always connect the negative (black) cable last.
Your vehicle is equipped
with a sealed battery, which
requires little maintenance.
Always keep battery termi-
nals and connections free of
corrosion. If cleaning is nec-
essary, remove corrosion
with a stiff wire brush. Wash
with a solution of one table-
spoon baking soda and one
cup water. Rinse well with
tap water and dry off with
clean shop towels. Coat the terminals with dielectric grease or
petroleum jelly.
Battery Removal
1. Remove the seat. The battery is located under the passen-
gers side of the vehicle.
2. Disconnect the black (-) battery cable first.
3. Disconnect the red (+) battery cable last.
4. Remove the battery hold-down strap.
5. Lift the battery out of the vehicle.
Battery Installation
Using a new battery that has not been fully charged can dam-
age the battery and result in a shorter life. It can also hinder
vehicle performance. Follow the battery charging instructions
on page 117 before installing the battery.
1. Ensure that the battery is fully charged.
2. Place the battery in the battery holder. Install the battery
hold-down strap.
3. Coat the terminals with dielectric grease or petroleum
jelly.
4. Connect and tighten the red (+) cable first.
5. Connect and tighten the black (-) cable last.
WARNING