Polaris 2013 BRUTUS Owner's Manual - Manual (Page 50)

49
OPERATION
Attachments (Models HD and HD PTO )
Installing And Removing Attachments
The PRO-TACH attachment system is used for fast changing
of buckets and other attachments. See the appropriate
Attachment Owner’s Manual to install other attachments.
Installing:
1. Remove the two
retainers (Item 1) and
pins (Item 2) from the
storage position.
2. Start the engine. See
page 41. Move the
gear selector lever to
LOW.
3. Lower the attachment
arm ant tilt the attach-
ment interface forward.
4. Slowly drive forward
until the front edge of
the attachment inter-
face is completely
under the top lip of the
attachment (Item 3).
5. Tilt the attachment
interface backward
until the attachment is
slightly off the ground.
6. Move the gear selec-
tor lever to PARK and stop the engine. See page 41.
7. Install the two pins
(Item 1) and retainers
(Item 2) (both sides).
8. Connect the auxiliary
hydraulic hoses (if
equipped). See page
46.
9. Connect the PTO
driveline (if equipped).
See page 51.
2
1
2
1
3
5
4