Polaris 2013 BRUTUS Owner's Manual - Manual (Page 73)

72
ATTACHMENT ARM
Removing And Installing (Models HD and
HD
PTO )
Installing:
WARNING! Avoid Injury.
Keep fingers and hands out of
pinch points when removing
and installing the attachment
arm.
1. Position the utility
vehicle so it is cen-
tered in front of the
attachment arm.
2. Remove the retainer
pins and pins from the
attachment arm (both sides).
3. Raise the attachment
arm and position it to
the vehicle mounting
frame. Install the two
pins (Item 1) and
retainer pins (Item 2).
4. Remove the lift cylin-
der retainer pin (Item
3) and the pin (Item 4).
5. Remove the tilt cylin-
der from the Stow Kit
(Item 5). Lower the tilt
cylinder down and rest
the rod end on the
attachment arm.
1
1
2
3
4
5