HEIDENHAIN SW 548328-05 - Manual (Page 162)

162 Cycle programming
4.4 T
u
rn
ing cy
cles
Cycle run
1 Calculate the proportioning of cuts (infeed)
2 Approach the workpiece from starting point for first pass
3 Plunge-cut at plunging angle A with reduced feed
4 Move at the programmed feed rate to the contour end point X2
or to the oblique surface defined by the end angle W
5 The contour is machined depending on the contour smoothing H:
6 Return and approach again for next pass
7 Repeat 3 to 6 until contour end point X2 is reached
8 Return to starting point on paraxial path
9 Move to the tool change point according to the G14 setting