HEIDENHAIN SW 548328-05 - Manual (Page 17)

HEIDENHAIN MANUALplus 620 17
3.1 Machine mode of operation ..... 72
3.2 Switch-on / Switch-off ..... 73
Switch-on ..... 73
Monitoring EnDat encoders ..... 73
Traversing the reference marks ..... 74
Switch-off ..... 75
3.3 Machine data ..... 76
Input of machine data ..... 76
Machine data display ..... 78
Cycle statuses ..... 81
Axis feed rate ..... 82
Spindle ..... 82
3.4 Setting up a tool list ..... 83
Machine with turret ..... 83
Machine with multifix ..... 83
Tools in different quadrants ..... 84
Filling the turret list from the database ..... 85
Filling the turret list ..... 86
Tool call ..... 87
Driven tools ..... 87
Tool life monitoring ..... 88
3.5 Machine setup ..... 89
Defining the workpiece zero point ..... 89
Homing the axes ..... 90
Setting the protection zone ..... 91
Defining the tool change position ..... 92
Setting C-axis values ..... 93
Setting up machine dimensions ..... 94
Calibrating the tool touch probe ..... 95
3.6 Tool measurement ..... 96
Touch off ..... 97
Touch probe (tool touch probe) ..... 98
Optical gauge ..... 99
Tool compensation ..... 100
3.7 "Manual Operation" operating mode ..... 101
Tool change ..... 101
Spindle ..... 101
Handwheel operation ..... 101
Manual direction keys ..... 102
Teach-in cycles in Manual mode ..... 102
3.8 Teach-in mode ..... 103
Teach-in mode ..... 103
Programming Teach-in cycles ..... 103
3 Machine mode of operation ..... 71