HEIDENHAIN SW 548328-05 - Manual (Page 503)

HEIDENHAIN MANUALplus 620 503
7.
3 T
ool data
Angle cutters
Select "New tool."
Select special tools.
Select special milling tools.
Select angle cutters.
The help graphics illustrate the dimensions of the tools.
Special parameters for angle cutters
DV
(Large) milling diameter
AZ Number of teeth
FB Cutter width
 FB<0: Large cutter diameter on front
 FB>0: Large cutter diameter on back
FW Cutter angle
DD Cutter diameter compensation
For further tool parameters, see page 489.
 For milling operations with constant cutting speed, the
milling cutter diameter (DV)
is used to calculate the
spindle speed.
 The number of teeth (AZ) parameter is evaluated for
G193 Feed per tooth
.