SMA POWER REDUCER BOX - Manual (Page 26)

6 Mounting SMA Solar Technology AG
26 REDUCERBOX-BA-en-16 User Manual
6.2 Mounting the Power Reducer Box on the Wall
1. Determine the mounting location.
2. Mark the position of the drill holes on the wall (spacing of drill holes: 75 mm).
3. Drill holes with a diameter of 6 mm at the marked points.
4. Insert wall plugs into the holes.
5. Screw in the screws and leave approximately 6 mm protruding from the wall.
6. Hang the Power Reducer Box on the screws.
6.3 Mounting the Power Reducer Box on a Top-Hat Rail
1. Hook both lower brackets of the Power Reducer Box under the lower edge of the top hat rail.
2. Push the Power Reducer box upwards and snap the top-hat rail into the upper brackets.