Yaskawa G5 Eliminator - Manual (Page 19)

Date: 07/01/04, Rev: 04-07 Page 19 of 27 TM.G5SW.015
3.0 Parameter Changes
3.1
Group A User Parameters
The user parameters are located within the “Initialize” menu selection. When the GPD515/G5
drive has been flashed with this software A2-11 through A2-32 constants are converted to the
parameters used to configure the drive.
3.2
Group b Applications – Function b1 Sequence
Display Constant Setting Display Description
Reference Source b1-01 05 Eliminator Ref Enables the Eliminator Software
3.3
Group H Terminal - Function H1 Digital Inputs
Display Constant Setting Display Description
80 Switch 1 DI Switch function with a common output to a NO and NC input
81 Switch 2 DI Switch function with a common output to a NO and NC input
82 MOP UP Increases the MOP value
83 MOP DOWN Decreases the MOP value
84 MOP RESET Resets the MOP value to the default value set in parameter P2-05
85 Number Hold Holds the last value input until de-activated
86 CASE DI 7 Reserved
Terminal 3 Sel
Terminal 4 Sel
Terminal 5 Sel
Terminal 6 Sel
Terminal 7 Sel
Terminal 8 Sel H1-01
H1-02
H1-03
H1-04
H1-05
H1-06
87 CASE DI 8 Reserved
3.4
Function H2 Digital Outputs
Display Constant Setting Display Description
40 CONNECTION 80 Switch function with a common output to a NO and NC input
41 CONNECTION 81 Switch function with a common output to a NO and NC input
Terminal 9 Sel
Terminal 25 Sel
Terminal 26 Sel H2-01
H2-02
H2-03
42 CONNECTION 82 Increases the MOP value
3.5
Function H4 Analog Outputs
Display Constant Setting Display Description
50 Case Monitor 1 Links the value in U1-50 to the selected analog output Terminal 21 Sel
Terminal 23 Sel H4-01
H4-04
51 Case Monitor 2 Links the value in U1-51 to the selected analog output
3.6
Group F Options
Constant F1-01, Pulses Per Rev is enabled in all control methods