0 custom software parameters, Group p eliminator parms, Function p1 eliminator p1 – Yaskawa G5 Eliminator User Manual
Page 21: Function p2 eliminator p2
Date: 07/01/04, Rev: 04-07
Page 21 of 27
TM.G5SW.015
5.0 Custom Software Parameters
5.1
New Program Group
Group P
Eliminator Parms
5.2
New Program Function
Function P1
Eliminator P1
Select Eliminator P1 to access parameters P1-01 to P1-10.
Function P2
Eliminator P2
Select Eliminator P2 to access parameters P2-01 to P2-10.
5.3
New Program Parameters
Parameter 1
P1-01 = 0
P1-01
Parameter
1
B B B B
This parameter is provided for user input. Refer to section 2.1.3.
Parameter 2
P1-02 = 0
P1-02
Parameter
2
B B B B
This parameter is provided for user input. Refer to section 2.1.3.
Setting Range:
0 to 65535
Factory Default:
0
Modify During Run:
Yes
Modbus Address:
0580H
Setting Range:
0 to 65535
Factory Default:
0
Modify During Run:
Yes
Modbus Address:
0581H