Yaskawa GPD 515/G5 to G7 - Manual (Page 27)

Product Transition Guide
Appendix 2- Parameter Differences
____________________________
PL.G7.02.TransitionGuide 4/21/04
Page 27 of 38
Yaskawa Electric America, Inc
GPD515/G5 Parameters G7 Parameters
Parameter
No.
Name
(DigitalOperator Display) Setting or Selection
Parameter
No.
Name
(Digital Operator Display)
Remarks on
Setting or Selection
— — — F5-03 DO-08 Channel 3 Output
Selection New Parameter
— — — F5-04 DO-08 Channel 4 Output
Selection New Parameter
— — — F5-05 DO-08 Channel 5 Output
Selection New Parameter
— — — F5-06 DO-08 Channel 6 Output
Selection New Parameter
— — — F5-07 DO-08 Channel 7 Output
Selection New Parameter
— — — F5-08 DO-08 Channel 8 Output
Selection New Parameter
— — — F5-09 DO-08 Output Mode
Selection New Parameter
0:8-channel individual outputs.
1:Binary code output.
2:Output according to
F5-01 to F5-08 settings.
F9-02 Option External Fault
Detection Selection
0:Always Detected
1:Only During Run F6-02 Option External Fault
Detection Selection Changed Parameter No.
F9-03 Option External Fault
Detection Operation
Selection
0: Ramp to Stop
1: Coast to Stop
2: Fast - Stop
3: Alarm Only F6-03 Option External Fault
Detection Operation
Selection Changed Parameter No.
F9-04 Trace Sampling Time — F6-04 Trace Sampling from
Communications Option
Board
Changed Parameter No.
TorqueReference/ F9-05
Torque Limit Selection
through DP-RAM
communication
0: Disabled
1: Enabled F6-06 Torque Reference/Torque
Limit Selection through
DP- RAM communication Changed Parameter No.
F9-06 DP-RAM Communication
Error Detection Operation
Selection
0:Ramp to Stop
1:Coast to Stop
2:Fast - Stop
3:Alarm Only F6-01 DP-RAM Communication
Error Detection Operation
Selection Changed Parameter No.