Hongdian H8951 3G/4G Wi-Fi router - Manual (Page 82)

5 Router config H8951 3G/4G Router
(2014-07-01) - 66 -
Parameter Details Operation
replaced [1-65535], it can be a range,
or a single port
Step 5 Single click “save” icon to finish.
When SNAT rule is configured port, protocol select "all", said select "tcp", "udp" two protocols; when
SNAT rule is not configured port, protocol select "all", said select "tcp", "udp","icmp" three protocols.
---END
MASQ rule configuration
MASQ is MASQUREADE.
Step 1 Log-on WEB GUI of H8951 3G/4G router.
Step 2 Click “Forward > NAT” to open “NAT” tab.
Step 3 NAT Type select “MASQ”, Configuration interface as shown in Figure 5-48.
Figure 5-47 MASQ configuration
Step 4 Configure MASQ rule parameter.
Table 5-24 MASQ rule Parameter instruction
Parameter Details Operation
NAT Type To select “MASQ” Select “MASQ”
Interface Interface includes:
 br0: use br0 interface as commutation
address between router & LAN and
external network
 Modem: use modem interface as
Select from Dropdown List