Maintenance, Order information toner cartridge replacement, Order information – iSys iTerra Elite II Color LED Plotter User Manual

Page 35: Toner cartridge replacement

Advertising
background image

June 2011: Revision 002

35

13.

Maintenance

Order Information

Only use iSys products to ensure the best quality and performance from your hardware. Using other products
may adversely affect your printer's performance and invalidate your warranty.

Item

Life

ELITE II ORDER NO.

Toner, black

11,000 Letter @ 5%

600-1360

Toner, Cyan

11,500 Letter @ 5%

600-1362

Toner, Yellow

11,500 Letter @ 5 %

600-1366

Toner, Magenta

11,500 Letter @ 5%

600-1364

Image drum, black

30,000 Letter pages *

600-1370

Image drum, cyan

30,000 Letter pages *

600-1372

Image drum, Magenta

30,000 Letter pages *

600-1374

Image drum, yellow

30,000 Letter pages *

600-1376

Transfer Belt

60,000 Letter pages *

600-1380

Fuser (120V)

60,000 Letter pages *

600-1381

Fuser (230V)

60,000 Letter pages *

600-1382

*Based on continuous print.

Toner Cartridge Replacement



Have a sheet of paper handy so that you have somewhere to place the used cartridge while you install the new one.
Dispose of the old cartridge responsibly, inside the pack that the new one came in. Follow any regulations,
recommendations, etc., which may be in force concerning waste recycling. If you do spill any toner powder, lightly
brush it off. If this is not enough, use a cool, damp cloth to remove any residue. Do not use hot water, and never use
solvents of any kind. They will make stains permanent.







NOTE: When the LCD display indicates TONER LOW, or if print appears faded, first
open the top cover and try tapping the cartridge a few times to evenly distribute the
toner powder. This will enable you to obtain the best “yield” from your toner
cartridge.

CAUTION! To avoid toner wastage and possible toner sensor errors, do not change
the toner cartridge(s) until “TONER EMPTY” is displayed.

WARNING! If you inhale any toner or get it in your eyes, drink a little water or bathe
your eyes liberally in cold water. Seek medical attention immediately.

WARNING! If the printer has been powered on, the fuser may be hot. This area is
clearly labeled. Do not touch.

Advertising