Epson StylusPro10000 - Manual (Page 34)

1-16
1-16 | Setting Up the Printer
4. Double-click the driver installation for your printer model. If you have
the Photographic Dye Ink model, double-click Install Stylus Pro
10000 With Photographic Dye Technology . If you have the Archival
Ink model, double-click Install Stylus Pro 10000 With Archival Ink
Technology .
5. Click OK in the next window to start printer software installation. You
see windows opening on your screen during driver installation. On
Windows 95 and NT, the Status Monitor 3 utility is also installed now.
6. Windows 95 or NT: Turn on your printer and go to step 7.
Windows 98, Me, or 2000: You see a window asking you to turn on
your printer. Press the
P
Power button until the Operate light comes
on. After a few moments, the software configures your printer port and
installs the Status Monitor 3 utility.
7. When you see a message informing you that installation is complete,
click OK .
8. Click the icon to exit the installer.
9. If you’re using Windows 95 or NT, or if the final installation
completion screen asked you to do so, restart your computer now.
If you want to share the printer with other computers, see the next section
for configuration instructions.
For instructions on using your printer software, see Chapter 4.
Setting Up Your Printer for Sharing
Follow the steps in the appropriate section to configure your computer to
share the printer on a network:
• “Setting Up on a Macintosh Network” on page 1-17
• “Setting Up on a Windows 95, 98, or Me Network” on page 1-19
• “Setting Up on a Windows NT 4.0 or Windows 2000 Network” on
page 1-22
Note
SPro 10000 identifies
the driver for the
Photographic Dye
Ink model, and SPro
10000CF identifies the
driver for the Archival
Ink model.
If you’re using Windows
2000 and have
connected your printer
with a parallel cable or
network interface card,
click the Stop Searching
button at step 6 and go to
step 7.