Epson StylusPro10000 - Manual (Page 64)

2-18
2-18 | Handling Paper and Other Media
Setting Paper Configurations
When you use non-EPSON paper or other media, you may need to register
the paper’s thickness, drying time and suction setting.
When you’re using a paper stock or other printing material for the first time,
always test it on a small print job. If the ink smears or printing is blurred,
you need to register the paper’s drying time, and thickness (or suction
setting). Registration is not necessary when you use EPSON media. You can
register up to four types of paper or other media. Then you can select the
registered values whenever you print on that particular stock.
Drying time determines how long the printer will pause between pages or
before cutting.
Registering Paper Thickness, Drying Time, and Suction
To register a new paper stock, load it into the printer and follow these steps:
1. Press the SelecType button until PAPER CONFIG. MENU appears on
the display.
2. Press the Item button. PAPER NUMBER=STD* appears on the display.
3. If you’re registering your first roll or batch of paper, press the + button
to select PAPER NUMBER=1 . Then press the Enter button.
For subsequent rolls, continue pressing the + button to select the
number you want to register.
4. Press the Item button. THICK. PAT=PRINT appears on the display.
Press Enter to print the paper thickness test pattern. You may see
PAPER THICK. NO.=1 on the display.
Following is a sample pattern:
Note
It’s a good idea to keep a
list of your registered
paper types and
numbers.
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17