Casio DT-10 - Manual (Page 8)

5
• Active SSIDs
The Active SSIDs table lists all the access points or peer stations (creator of IBSS) in the vicinity with each
record displaying the following six fields (The table may not display all the fields on the screen. Use horizontal
scroll bar to check all):
™ SSID – Network Name of the access point or peer station. A link icon with signal strength is also
shown.
™ Signal – Signal Strength in percentage for that SSID.
™ Mode – An icon shows whether it is an access point , or a peer station .
™ Channel – The channel being used and the WEP key status. ( stands for WEP Key-On, and
for WEP Key-Off).
™ SupRate – Supported data rate of the access point or the peer station.
™ BSSID (MAC Addr) – BSSID or MAC Address of the access point or the peer station.
1.1.2.２ Operation Buttons
• Add
Click on this button to add the selected (highlighted) profile into the Preferred Profile table. If the SSID has
WEP Key On, the Settings window will pop up for you to enter the WEP Method, Encryption Key, and Key ID.
Click OK button in the Settings window after finishing the configuration, and the SSID with its profile will be
added into the Preferred Profiles window. No window will pop up when adding an SSID with WEP Key Off. It
will be added into the Preferred Profile table directly at the click on Add button.
• Apply
Click this button to associate/join your station with the SSID you selected. This SSID can be either from the
Preferred Profile or from the Active SSIDs table. When Applied, the Status tab window will display the status
of the wireless connection. If the association fails, an automatic search for another AP in the preferred profile
list will take place, trying to associate in the order of your preference.
• Refresh
Click this button to start a new search for all available access points or peer stations in the vicinity.
1.1.2.３ Profile Settings Window
Tapping on the New or Edit button to enter the profile setting window. It has two tabs.
To create a new profile to the preferred list one can click the New button (described in Section 1.1.2.１) without
selecting (highlighting) any existing profile
. An Add New Preferred SSID window will pop up as shown in Figure
5.
To modify a profile one can select (highlight) a profile and click the Edit button. A Modify Existing Preferred
SSID window will pop up as shown in Figure 5, except that the SSID, Type, TX Rate, and Channel fields are
unchangeable in AP mode, whereas TX Rate and Channel fields can be changed in Peer-to-Peer mode.
1.1.2.３.１ Network Profile Tab
Copyright© 2005 CASIO COMPUTER CO., LTD.
All rights reserved.