Epson GT-30000 - Manual (Page 45)

Installing the Software
39
If you’re done installing software, remove the EPSON GT-30000 Scanning Tools
CD-ROM and restart your computer. Then follow the instructions in the next
section to make sure your scanner is operating properly.
If you want to install the ISIS driver, PixTools QuickScan, or Presto! PageManager
continue with the instructions under “Installing Additional Software” on page 49.
Testing Your Scanner Connection (Windows 98)
You need to verify that your scanner was properly connected and the software was
installed correctly. Follow these steps to test scanner operation:
1. Open the Windows Control Panel and
double-click the Scanners and
Cameras icon to open the Scanners and
Cameras Properties window.
2. Make sure EPSON GT-30000 is selected,
then click the Properties button.
3. If necessary, click the General tab. Click
the Test Scanner or Camera button. If
the scanner is operating properly, Device
Ready appears next to Status.
4. Click OK to close the Properties window.