RIGOL DSG3000 Series - Manual (Page 37)

Chapter 2 Command System RIGOL
DSG3000 Programming Guide 2-17
[:SOURce]:AM:FREQuency
Syntax [:SOURce]:AM:FREQuency <value>
[:SOURce]:AM:FREQuency?
Description Set the AM modulation frequency.
Query the AM modulation frequency.
Parameter Name Type Range Default
<value> Integer
100mHz to 1MHz (Sine)/
100mHz to 20kHz (Square)
10kHz
Explanation  When <value> is set in "Number" form, the default unit is Hz, for example,
20000. In addition, <value> can also be set in "Number + Unit" form, for
example, 20kHz.
 The default unit of the return value is Hz.
 After the modulation frequency is set, you can use the up/down direction keys
or knob to modify the modulation frequency at the current step. You can query
or set the current step using the
[:SOURce]:AM:FREQuency:STEP[:INCRement] command.
 When "Ext" modulation source is selected, this operation is invalid.
Return Format The query returns the AM modulation frequency, for example, 20000.
Example :AM:FREQ 20kHz
:AM:FREQ?
Related
Commands
[:SOURce]:AM:FREQuency:STEP[:INCRement]
[:SOURce]:AM:SOURce
[:SOURce]:AM:FREQuency:STEP[:INCRement]
Syntax [:SOURce]:AM:FREQuency:STEP[:INCRement] <value>
[:SOURce]:AM:FREQuency:STEP[:INCRement]?
Description Set the AM modulation frequency step.
Query the AM modulation frequency step.
Parameter Name Type Range Default
<value> Integer 100mHz to 500kHz 1kHz
Explanation  When <value> is set in "Number" form, the default unit is Hz. In addition,
<value> can also be set in "Number + Unit" form, for example, 3.55kHz.
 The default unit of the return value is Hz.
 After the modulation frequency step is set, you can use the up/down direction
keys or knob to modify the modulation frequency at the current step. At this
point, you can query or set the modulation frequency using the
[:SOURce]:AM:FREQuency command.
Return Format The query returns the AM modulation frequency step, for example, 3550.
Example :AM:FREQ:STEP 3.55kHz
:AM:FREQ:STEP?
Related
Command
[:SOURce]:AM:FREQuency