TA Triumph-Adler CLP 4532 - Manual (Page 49)

Using the Operation Panel
2-33
Default Font
You can select the default font for the current interface. The default font can be one of the internal
fonts or a font that is downloaded to the printer memory or stored in a memory card, hard disk or
option ROM.
In this menu, you can also set the type and pitch for Courier and Letter Gothic; as well as to print a
font list.
1 Press [Menu].
2 Press or repeatedly until Font > appears.
3 Press . Press or until >Font Select > appears.
4 To select an internal font, make sure that Internal is displayed
and press . The display changes. If Internal is not displayed,
press [OK], then press
or until it appears.
To select an optional font, press [OK] while >Font Select > is
displayed. Press
or repeatedly until Option appears and
then press [OK]. Press next to display the font selection shown above. You can perform this
operation only when optional fonts are installed in the printer.
The letter before the number indicates the location of the font, as shown below:
5 Press [OK]. A blinking question mark (?) appears.
6 Press or repeatedly until the desired font number appears. For font numbers of the internal
fonts, refer to Printing Lists of Fonts on page 2-36.
7 When the desired font is displayed, press [OK].
8 Press [Menu]. The display returns to Ready.
Selecting Regular or Dark Courier/Letter Gothic
Courier or Letter Gothic font thickness can be selected as Regular or Dark. In the procedure
below, it is assumed that Courier is selected. The procedure is the same for Letter Gothic.
1 Press [Menu].
2 Press or repeatedly until Font > appears.
Fo n t >
>F o nt Se l ec t >
I nt e rn a l
I Internal font
S Soft (downloaded) font
M Fonts in optional memory card
H Fonts in RAM disk or optional hard disk
O Fonts in optional ROM (API)
>> I0 0 0
>> ? I0 0 0
Fo n t >