TA Triumph-Adler DC 2015 - Manual (Page 11)

CHAPTER 2 NAMES OF PARTS
2-2
1 Original cover
(Open/close to set the original on the platen.)
2 Operation panel
(Contains the keys and indicators for operating the copier.)
3 Left cover handle
(Hold to open the left cover.)
4 Left cover
(Open when a paper misfeed occurs.)
5 Multi-Bypass
(Load paper here when copying onto small-size or special paper.)
6 Insert guides
(Be sure to set the paper width when loading paper on the multi-
bypass.)
7 Support guide
8 Toner cartridge
9 Toner cartridge release lever
(Operate to replace the toner cartridge.)
0 Waste toner tank
! Waste toner tank release lever
(Operate to replace the waste toner tank.)
@ Cleaning shaft
(Pull and push back in after toner cartridge replacement or when
copy images become soiled with toner.)
# Front cover
(Open to replace the toner cartridge or waste toner tank.)
$ Main switch
(Turn ON (|) before starting to make copies.)
% Copy store section
(Copied paper is stored here.)
^ Ejection section
& Drawer
(Holds up to 250 sheets of standard paper [standard paper as
specified by our company].)
* Platen
(Set originals here for copying. Place originals face-down with the
edges aligned with the size scales on the left and rear sides of the
platen.)
( Original size scales
(Be sure to align the original with these when setting the original
on the platen.)
) Length adjustment plate
(Adjust to the length of the paper to be set in the drawer.)
⁄ Width adjustment lever
(Hold the lever and adjust the width guide to the width of the paper
to be set in the drawer.)
¤ Drawer bottom plate
(Push down when loading paper.)
‹ Handles for transport
(The right two handles are indented handles. The left two become
handles when pulled out.)