TA Triumph-Adler DC 2015 - Manual (Page 15)

CHAPTER 3 PREPARATIONS BEFORE USE
3-2
5
6
7
1
Set the paper flush against the left-hand wall of the drawer.
IMPORTANT
* There is a sticker (“ 1 ” in the illustration) indicating paper capacity
attached to the inside of the drawer. Do not load paper above this
limit.
* When loading paper into the drawer, make sure that the copy side is
facing upward. (The copy side is the side facing upward when the
package is opened.)
* Check that the length adjustment plate and width guide make
secure contact with the paper. If there is a gap, adjust the position of
the length adjustment plate or width guide.
Set the supplied paper size sheet so that the size of the
paper loaded can be checked by looking at the front of the
drawer.
Gently push the drawer back in.
* Check that the paper is kept under the claws of the drawer.
If not, reload the paper.
* Before leaving the copier in disuse for a prolonged period
of time, remove the paper from the drawer(s) and seal it in
its original packaging to protect from moisture.
(3) Loading paper into the multi-bypass
Special paper as well as standard paper can be loaded into the multi-
bypass. When copying onto special paper, be sure to use the multi-
bypass.
* The number of sheets of standard paper, colored paper and
letterheads that can be loaded into the multi-bypass differ depend-
ing on the paper size.
11" x 17" and 8 1/2" x 14" (A3, B4 and Folio): 25 sheets
11" x 8 1/2" and 5 1/2" x 8 1/2" (A4 to A5 [vertical]): 50 sheets
* The types of special paper and the number of sheets that can be
loaded in the multi-bypass are:
• Transparencies: 1 sheet
• Standard paper (120g/m
2 , 160g/m 2 ): 1 sheet
Open the multi-bypass.