TA Triumph-Adler DC 2015 - Manual (Page 33)

CHAPTER 6 COPIER MANAGEMENT
6-2
1
2
4
5
6
3
7
8
9
(2) How to set the copy management mode
Press and hold both of the copy exposure adjustment keys
and the * key of the numeric keys for 3 seconds. "d00" (mode
code) appears on the copy quantity display.
The mode code changes each time the Zoom (+) key or
Zoom (-) key is pressed. Select the desired mode code by
referring to the table shown in "(1) Copy management
modes".
Press the enter key.
If "d01" or "d04" is selected, proceed to the next step.
If "d02" or "d03" is selected, proceed to step 6.
If "d05" is selected, the copy management list will be printed
out. Proceed to step 10.
The setting code changes each time the Zoom (+) or Zoom (-)
key is pressed. Select the desired setting code by referring to
the table shown in "(1) Copy management modes".
Press the enter key. The display returns to that for step 2. To
end the copy management mode setting, proceed to step 11.
Enter the ID-code (4 digits) to be registered or deleted with
the numeric keys.
* If a wrong code is entered, press the Stop/Clear key and
enter the correct code.
Press the enter key.
When registering, the display returns to that for step 2. To
end the copy management mode setting, proceed to step 11.
When deleting, proceed to the next step.
Confirm whether or not to proceed with the deletion. To
cancel the deletion, leave the setting as "2"; to proceed with
the deletion, press the Zoom (+) or Zoom (-) key to change
the setting to "1".
Press the enter key.
The display returns to that for step 2. To end the copy
management mode setting, proceed to step 11.