TA Triumph-Adler DC 2015 - Manual (Page 29)

CHAPTER 5 FUNCTIONS
5-4
1
3. Layout copy
Two or four originals can be combined into a single copy.
The borderline of each original can also be marked with a solid line or
dotted line.
* Layout copying requires the optional memory board.
* The initial setting of the borderline can be set. (See “Layout (border-
line)” on page 6-6.)
* The original and copy paper must be the standard size.
● 2 in 1
Use this mode to copy two originals onto one sheet.
(When setting the originals on the platen, originals are arranged in the
order of 1 and 2.)
● 4 in 1
Use this mode to copy four originals onto one sheet.
(When setting the originals on the platen, originals are arranged in the
order of 1, 2, 3 and then 4.)
* In the 4 in 1 mode, available modes differ depending on the
orientation of the originals. The initial setting of the orientation can
be selected from vertical and horizontal. (see “Layout (4 in 1)” on
page 6-6.)
To change the type of the borderline, press and hold the
layout key for 3 seconds. “F20” appears on the copy quantity
display and, 2 seconds later, a number appears. If you do not
wish to change the type of the borderline, proceed to step 4.
The number displayed indicates the type of the borderline as
follows:
1: None
2: Solid line
3: Dotted line